Transformation of the power amplifier based on the MEG in the eternal power generators

Consider the physical scheme MEG. In the center of the rectangular core installed magnets made of neodymium. Magnets relate to each side of the core on the inner part of it. At core, the coil has not been established.
It interacts with the magnet core?
Since the magnet is located in the center, its magnetic field will be divided equally between the left and right half of the core.
Now place the coil at the core. Uses two control coils located on the upper horizontal part of the core, on both sides of the package of magnets. Also, set off two coils located on each side of the core rod. Weekend coil is not shown.
Now send all the magnetic flux in one direction – in the right half of the core, contrasting the field of the magnet field created by the left control coil. Which force field should create a control coil to do this? The answer of course – half the entire field of the magnet – it is such a quantity field induced in the left half of the core. Another coil control is off, through her current does not flow and it does not affect the process of reversal. Core should not be allowed to reach magnetic saturation, or require more energy to control field of the magnet.
If we now turn off the control coil, what happens?
Remember, both the control coil is now disabled. The magnetic flux return to the original, the initial state, sharing equally in each half of the core, in accordance with the first pattern. The magnet needs to be any help to do this? No, of course not. Energy was expended only for the fact that to send the entire magnetic flux in the right half of the core.
In each output coil will be induced by a quarter periods, because in the beginning we are only half the flow of a switch magnet in the right half of the core from the left. So the total changes – Bmag / 2.
In the next cycle of the magnetic flux returns to its original state, he is divided between two halves of the core. At this point, both the control coils are switched off. Only when the magnetic flux reaches an equilibrium point, turn the other control coil, redirecting the entire magnetic flux in the left half of the core. Each roll should always switch only half of the magnetic flux. After the first half period is 100% change of magnetic flux in each output coil. It spent input power is equal to half off. We will strengthen the control coil only for half of each cycle. This means that we have a theoretical maximum efficiency = 2.0. We use a package of magnets as a source of magnetic flux and “allow” him to do half the work. See the following figure for the second half period. This figure simulates the steady state, after the switch occurred after passing the voltage through zero.
How can we improve this device? Use a high switching frequency, more exotic core materials could help. The higher the rate of change of flux (dB / dt) – the greater the output voltage. Therefore, higher frequency is better. Tom Bearden MEG was at its efficiency = 5. It is possible that the use of specific nano crystalline core and the use of the frequency of 40 kHz can yield efficiency = 5. Also, changing the duty cycle control pulses could help reduce power consumption.
Jean-Louis Naudin has efficiency = 1.75, using a standard permalloy steel core. This confirms my hypothesis. Large losses can not afford to get efficiency = 2 with this material. So at the minimum, until you can build a generator with a power gain of 1.75 times. He alone could allow you to reduce your electricity bills by about half, if you put this device between your meter and your appliances. You can also cascade them to obtain 15 kW, consuming only 100 watts. Requires approximately 9 stages to achieve this.
Jean-Louis Naudin has shown that it is possible. You need only large magnets, magnetic cores and coils.
Power gain in cascaded stages
This table is obtained, based on the fact that the device consumes 100 watts in the first stage, and each stage has a gain of 1.75 times the power. With each step the output power increases.
This means that you could create a powerful energy system that will provide all your household needs, while consuming only 100 watts from the mains. You only need to choose the right frequency for all of your existing devices. Using the converter, you could use a battery or petrol generators to run the device and then send part of the power at its entry. If the control scheme will allow, then one or two stages would be sufficient.
Thus, the power gains for this amplifier, which acts here as a candidate for perpetual motion machine is about two. When used as a magnetic conductor over the quality of magnetic material and high-frequency current rectangular shape can be increased up to 5. And it seemed that this limit. Author of the idea does not extend beyond the age-old habits and in his imagination does not extend beyond the plane.
Control coils are fed from the network through a special electronic control unit, and the main side coil generating electricity and sending it to the load. By directing the energy of these coils on the control coils of the next more powerful stage, you can get a higher yield of energy. And so to obtain the necessary power of 10-15 kW. And there are several options to form a tree amplifiers.
But nothing prevents us from magnetic core to the spatial cross, located in the center column of neodymium, i.e. part of the management problems to ensure, through the geometry of the system. If similarly combine three O-shaped core, then we have tripled the gain, while preserving the principle of the considered power amplifier. If desired, the number of O-shaped cores, combined in a single volume construction can be significantly increased. The main thing is to design a management system that each cycle would begin filling the energy of all sectors of the magnetic core, and the second phase would overlap with all sections, except for one with an output coil, relaying all the magnetic flux only in one section with the output coil. It seems that, for each section must include only the control coils, and for the removal of energy needed just one output coil and input coil is only needed for power transmission from the network at the time of startup.
Even at the crossroads of three such rings can immediately get a power gain of 6 times. In the selection of magnetic elements can get the gain to 30. Now, if part of the output power after the promotion of the working mode of the guide for management, the power amplifier becomes a perpetual motion machine, pumping (redirect!) Energy from the earth’s electromagnetic field in vain. Worry about the loss of the Earth electromagnetic field should not be, as this field is supported by a stream of charged particles from the sun, whose power is much higher capacity of all plants in the world millions of times. Especially after the use of this energy is still goes to the energy balance of Earth.
We thus simply redistribute the energy flows in their favor. And while the energy reservoir called the Sun is full enough. Perhaps in the future in 3-4 billion years, people have to carry on the war for the remains of the energy of the Sun, as a lead among themselves around the decaying carcass of the elephant died, but there is a problem not worth it. The main thing is to make the next stage proper transformer capacity. You can even arrange disposal with the resulting loss of energy from the heat. But it is detail.
So our real perpetual motion machine, or rather, self-governing power amplifier, obtained from MEG, will extract energy from the Sun from the Earth’s electromagnetic field. To ensure that the system does not spontaneously “fell apart”, it should be powered from the mains or battery, just in case to keep, temporarily disabling it automatically when you exit the working mode. And then, with an external network of energy on a penny at the time of promotion of our perpetual motion, after this installation on a stationary mode, we can temporarily disconnect from the network and pumping energy from the earth’s electromagnetic field in vain, and, more importantly, virtually forever. This will be the practical realization of perpetual motion.
One of the tales, which give us some academics, that the perpetual motion machine, as a source of additional energy, is impossible – is a story about Maxwell’s demon. In this tale will be divided tank with gas wall with a small hole, which has put a Maxwell’s demon (another blasphemy) with the task flow in a section of container only fast molecules, but not slow. I grieve that so if it had been found to supply power to Maxwell’s demon, a perpetual motion machine could be implemented, otherwise – no.
So what’s the matter? We humans are not greedy. We are from all energy bestowed by God and Nature and 10% is sufficient. And if we accept every 10-th of the gas molecules give fast food to Maxwell’s demon, the remaining 90% would get us to have nothing. We agree with the fact that the device wall and the holes in it will also have to expend extra energy, but only one time. So, being fed by us demon-this is a device for controlling process gas separation into fractions of fast and slow molecules, which help to set the partition with a hole. And if the energy consumption for the content of Maxwell’s demon, along with the installation of perforated partitions will be less than the energy trapped so the flow of energy, then it is a real perpetual motion machine – power generators. And the other we do not need. So you can and Satan (main line) to get to work on people, if properly and correctly evaluate its work and through work for the benefit of people turn it into a normal person. In particular, this principle works all cell walls and membranes, for example, in the kidneys and lungs.
And the whole system with the Maxwell’s demon as a peon at a cart outside energy is transformed into an analog power plant. There, too, must begin to block the river, and then have to build a hole in a dam with a control system and generator, and then the system management is entrusted to catch the rapid flow of water from the headwaters of the river through the eternal cycle of water in nature and generate electricity for us, always hungry consumers.
And the issue of perpetual motion rests not in the impossibility of perpetual real power generators, and sophistical arguments of our academics, like those who argued that Achilles will never overtake the tortoise. But the two guards at the gates of the city, impervious to the salary for mayor in the city only decently dressed people, and there is a real analogue of Maxwell’s demon. And while the head of the city for security guards have gold, food, clothing, weapons, etc., the real perpetual motion machine will work properly and to divide people into rich and poor.
Once, in principle, any power amplifier can be turned into a kind of a real perpetual motion machine, do not even know what kind, it turns out that people have constant sources of energy enormous power not needed. For enough to have a network of public power as an initial promotion of any power generators, and more energy from the external public network is no longer needed. For example, each apartment may have generator power to supply all household appliances, which will not only provide electricity for free, but also heat, cold, etc. If necessary, the power of the power generators can easily increase or decrease, depending on current needs. All this can be trusted electronics. That’s when “my house” turns into “my fortress.